Launching Boot Camp Assistant

Created: Tuesday, August 16, 2011, posted by Geetesh Bajaj at 4:30 am

Updated: at



1 Star2 Stars3 Stars4 Stars5 Stars (2 votes, average: 5.00 out of 5)
Loading...

If you have fulfilled all requirements for installing Microsoft Windows 7 on your Mac using Boot Camp, then spare an hour or two and get started:

  1. Close all applications on your Mac so that you can just see your Desktop. Choose the Go | Utilities menu option, as shown in Figure 1.

    Access the Utlities option
    Figure 1: Access the Utlities option

  2. This opens the Utilities folder within your Applications. Here you will find the Boot Camp Assistant application, as shown in Figure 2. Double-click to launch the Boot Camp Assistant.
    Boot Camp Assistant
    Figure 2: Boot Camp Assistant
  3. This summons the Boot Camp Assistant’s first screen as shown in Figure 3. As shown in the screen, Apple recommends that you back up your entire disk before proceeding, assuming you have backed up your important stuff, proceed by clicking the Continue button.
    Starting with Boot Camp Assistant
    Figure 3: Starting with Boot Camp Assistant
  4. You are now prompted to either download the additional software that you will need after installing Microsoft Windows 7 (see Figure 4). This is typically the drivers for your Mac hardware and are included in the original DVD or CD media that was in the box that contained your Mac hardware; most of the time this is the same media that you use to do a Restore of your Mac software. Even if you don’t have this additional software handy, you are allowed to download it now from the Apple site. Most of you who upgraded from Snow Leopard to Lion using the Mac AppStore will have to choose the download option since you probably have no media. If you do have the media or have already downloaded the software before, you can go ahead and choose the second option. However if you choose the first option to download the additional software now, be prepared for a fairly large download. Make your choice and click the Continue button.
    Do you need the additional software?
    Figure 4: Do you need the additional software?
  5. Assuming you chose the Download option, you might next see a window asking you to input your admin password. Enter your password, and click OK. Boot Camp Assistant will now start downloading the drivers and other software, as shown in Figure 5, below.
    Additional software being downloaded
    Figure 5: Additional software being downloaded

In the next post in this series, I’ll show you what you need to do next to get Windows 7 installed on your Mac using Boot Camp.


Related Posts

Using Boot Camp to Create a New Partition First make sure that you have the additional software you need, such as Windows drivers for your Mac hardware. Then, once you launch Boot Camp Assista...
Requirements for Installing Windows 7 Using Boot Camp If you want to install Microsoft Windows 7 on a Mac running Mac OS X Snow Leopard or Lion, using Boot Camp, you will need to fulfill the following req...
What is Boot Camp? Boot Camp is a technology built into Intel chip-based Macs that allows you to create a separate partition on your Mac OS hard disk that can run Micros...
Before Installing Lion: Check for Application Compatibility Before you install Mac OS X Lion, take a moment to check if all applications on your computer are compatible with the new OS. The reason why you need ...

Microsoft and the Office logo are trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries.

Plagiarism will be detected by Copyscape

© 2000-2018, Geetesh Bajaj - All rights reserved.